ALUMINUM MAGAZINE CARRIER MOLDS

ESTIMATED: 2-3 Weeks Shipping Time

Take your holster making to the next level with aluminum molds.  These will take constant heat and never warp.  All edges have a slight chamfer to remove all sharp corners as well as making the demolding process much easier.  These molds also have built in air holes, no need to drill your own!

Available in limited quantities for limited models.

(HDPE router trim jig)

Single Taco style magazine carrier with FOMI blocking and .25" gap for adjustable retention built in.

Each mold is designed to make the manufacturing process simple and fast.  These are designed to be used with membraneless vacuum forming, but can also work with a membrane former.

*The idea behind the design is that once the shell is pressed there will be an outline for you to follow with your bandsaw.  

*This will allow you to trim the shell just slightly oversized with no need for tracing or measuring.  

*Once you have trimmed on the bandsaw, take the shell to the drill and you will drill out all the indicator holes that are premarked in the shell.  

*You will then attach the shell to the router trim jig with a standard .375" or .5" 8-32 screw ( same screws most people use on holsters).  

*Run your router jig along the bearing on your router bit.  

*After that it's just a matter of folding, buffing and assembly. 

AR15 mold designed with 1.5" hole spacing for TEKLOK or molle locks